CERTAINTEED 1.25kg Easi-Fil White Light Repair 90 Setting Compound

• Used to prefill joints, to embed joint tape, and to conceal joints, fasteners and trim accessories on gypsum wallboard as well as for interior patching and repair work
• Specially formulated to harden with very little shrinkage 90 minutes after mixing
• This enables drywall joints to be taped andfirst coated with Lite Sand 90, allowed to harden, and then finished with ProRoc Ready-Mixed All-Purpose Drywall Compound, all in the same day

PRECAUTIONS:

• Do not use in mechanical tools
• Do not mix with any other material
• Use only clean water and containers
• Application tools and mixing equipment shouldbe thoroughly cleaned between each batch
• Contaminants can adversely affect the compound's working life
• Discard the compound when it begins to harden
• Adding more water will not prolong the workinglife
• Maintain a minimum 13 degrees C (55 degrees F) room and material temperature during application and until completely dry
• A relative humidity between 20% and 70% is required for proper drying of this material
• When compound first hardens, it is still wet inside and should not be painted until it is completely dry throughout
• A minimum drying time of 24 hours is requiredbefore painting
• Compound will not adhere to smooth non-porous surfaces
• Keep out of reach of children

FEATURES:

• Specially formulated to be easy to sand
• Lighter than regular setting compoundsproviding similar coverage
• Low shrinkage for trouble-free joint taping
• Mixes to a smooth, easily applied compound

COVERAGE:

• Approximate coverage is 26 kg of powder per100 m2 (1000 ft 2) of drywall panel
• Up to 400 sq.ft.

STORAGE:

• Rotate stock to avoid aging problems
• Use within 60 days of delivery
• Store in a dry place

APPLICATION INSTRUCTIONS:

• Wallboard joints are normally finished using three coats of compound; the first to embed the tape, the second to cover the tape, and the third to finish the joint
• Can be used for the first and second coats
• ProRoc Ready-Mixed All-Purpose DrywallCompound is used for the third coat
• Apply the first coat to the joint in a bandabout 64 mm (2-1/2") wide
• Tape over joint and embed with a broadknife
• Allow to dry for 90 minutes
• Apply second coat feathering it 50 mm(2") beyond first coat
• Allow to dry as above
• Apply two coats of compound to depressionsmade by fasteners and to corner beads and other trim accessories
• Allow to dry as above between coats
• Note: apply third coat to joints, fastenerdepressions, corner bead and other trim accessories using ProRoc Ready-Mixed All-Purpose Drywall Compound
• Allow to dry for 24 hours before sanding
• Use 120 grit sandpaper and a hand or pole sander
• Do not sand the surface of the wallboard paper
• For best results, apply a primer-sealer priorto painting or wallpapering
• For severe lighting conditions, or if a glosspaint is to be applied as the finish coat, it is recommended that the entire surface of the wallboard receive a skim coat of compound before applying the primer- sealer
• This will assist in equalizing the rate of absorption of the gloss paint and help to avoid flashing at the joints

MIXING:

• Mix only as much compound as can beapplied in 45-60 minutes
• To prepare contents of a 15 kg bag, pourapproximately 8 litres of clean, cold water into a clean pail of suitable size
• Add compound to water
• Do not stir too vigorously or for too long
• Excessive mixing will shorten the workinglife
• The correct consistency is a smooth creamy mixture

DRYING TIME:

• Approximately 24 hours depending ontemperature and relative humidity